Description

Vertial wheelchair lifts for disabled people has been widely used in various occasions, indoor and outdoor.Wheelchair lifts make it easier for disabled people to go up and down stairs.

The operating procedures :

(1) The lifting platform has been strictly debugging, arbitrarily adjust the regulator valve.

(2) Carefully check the hydraulic, electrical system, no leakage or bare phenomenon before use, do not loose all the joints and fasteners before you can use.

(3) Power on, start the motor, empty lift, check the hydraulic system before use.

(4) The center of the load should be as close as possible to the center of the work surface. The moving doors at both ends of the guard railing should be locked before working.

(5) The lifting platform shall work strictly in accordance with its prescribed carrying capacity.

(6) The lifting platform is strictly prohibited from moving and shaking during the rise and fall.

(7) Any unusual noises during the work should be stopped immediately to avoid injury to personnel or damage to equipment

(8) After the work completed, you should lower the platform, cut off the power supply, and close the legs, pushing the platform into the specified position

Technical parameters：

Outer size :  1650mm(L)*1100mm(W)

Pit size: 1700mm*1150mm*250mm

Max height : 10000mm

Bottom height :  8250mm

Installation:  No pit-mounted (fixed directly to the level of C30 concrete floor, concrete thickness of not less than 200mm)

Rising speed :  60mm/s （hydraulic）    40mm/s（screw）

Max load :  250kg
Shield form :  90°or 80°

Drive mode ：Precision screw-driven or driven hydraulic power unit

Voltage: 220V/50HZ/25A (or customized for local power supply)

Lift control： Rocker operation run from the reset switch

Outbound form： Outbound boxes or columns were installed in the upper and lower layers parked near a wall or floor, the upper and lower linkage platform

Working condition： Indoor and outdoor

Working temperature： -20°C—60°C

Safety board： The warp automatically rises when the device is running up, preventing the wheelchair from sliding out of the platform.
Anti-Fall protection:  the main sub-nut relying on transmission, joint control operation anti- fall protection.

Overload protection:  Over-current relay control.
Emergency stop:  Press the emergency button switch can control the machine to run up or down

Emergency descent:  Hand shake of the operation or use of a manual pressure relief system memory to enable the implementation of the emergency battery emergency lowering function

Safety net:  Lift the floor drops below the safety net in case of an obstacle to stop running immediately dropped

Inquiry Us